083-265-000 Stainless Steel Sheet Metal Screw (20 Pack)
#10 1/2" Pan Head A2 Phillips Head Stainless Steel Sheet Metal Screw 20 Pack. Replace those unsightly rusting, loose or missing cabinet screws with our Stainless screws for a neat finish. Oversized to accommodate loose cabinet or stripped holes.
238-006-666 Clamp Kit 8 Foot 6 Gauge Parrot Jaw
8' 6AWG Welding Wire Lead Set with heavy duty polished clamps featuring coated clamp handles. a 50 lb. Jaw Strength provides positive connections and color coded wires make for easy identification. These even have molded strain relief built on the cables. Ring terminal connections make installation a snap.
246-041-666 Universal Selector Knob
246-041-666 Universal Selector Knob with set screw for controls with 1/4" Stem. Replaces all knobs with 1/4" diameter shaft. Fits 1/2 shaft and 3/4 style shaft stems.
246-273-666 Universal Mechanical Timer 2 Hour With Knob
120 Minute mechanical timer with knob. 120 minute total time two 1/4 spade terminal connections, no finish bell. Replaces older timer 246-337-000, 246-167-000, 246-167-666. Mounting on your timer may be different than the replacement, inspect your unit before purchase, some older units may have had electric timers which may require rewiring. (Includes Screws)
Discontinued See TJ1-120MHB
246-408-000 6 Position Rotary Selector Switch (No Knob)
246-408-000 6 Position Rotary Selector Switch (No Knob). This switch has been modified from the original metal stem design to a plastic stem and the pin locations have changed. Switch should be wired number to number not by tab location.
Discontinued See 246-408-666
246-408-666 Rotary Selector Switch 6 Position With Knob
246-408-666 Rotary Selector Switch 6 Position With Knob. This switch has been modified from the original metal stem design to a plastic stem and the pin locations have changed. Switch should be wired number to number not by tab location. Includes instructions.
865-799-666 Voltmeter Horizontal W/ Control Board
Snap-In installation, no tools required. 0-20 Volt Range, 0-100% Charge Scale, Alternator Test Scale, Reverse Polarity Indicator Light (Red), Charge Complete Indicator (Green) 247-120 Meter & Circuit Board, 1/4" Spade Terminal Connections.
865-850-666 Rectifier Assembly
865-850-666 Rectifier Assembly, 250 Amp Cycle Duty 60 Amp Continuous Duty. 12 Diode Rebuildable Daisy Wheel Design.
S29420-24 Century Battery Charger Clamp Holder
S29420-24 Century Battery Charger Clamp Holder With Screws. Now you can stow your clamps in a safe place that doesn't get in the way, drag the ground or short out. Fits any round or flat bar battery charger handle. If using as a universal fit drilling two holes will be necessary.
TJ1-120MHB Universal Battery Charger 2 Hour Mechanical Timer
TJ1-120MB Universal Mechanical 2 Hour Timer With Finish Bell. Mechanically controls charging in timed Mode, has "Hold" for manual un-timed charging. Single Pole Single Throw (SPST) Switch rated 15 amperes. Termination is designed to accept 1/4" Quick Disconnect terminals. Includes mounting screws. Replaces many older mechanical timers.