The 6080A Associated 6 Amp Battery charger for "Flooded" or wet automotive and "Maintenance Free" batteries. Charge up to 36 Cells (6 batteries) in Series. New technology enables higher output voltage for charging new batteries and rejuvenating sulfated batteries. Fully charges six maintenance-free batteries at a time. Has an isolated transformer for better safety, plus circuit breaker protection. Includes five charging leads. Mounts on wall or bench

The Associated Model 6065 battery charger is designed to charge 1 to 10 12 volt automotive batteries in parallel, in parallel, in less than 24 hours. Designed with the fleet or high volume shop in mind. Great for salvage yards as well. The multiple charge rates allow batteries to be slow charged or fast charged at a rate not to exceed 30 amps output of the charger. Patented multi-diode rectifier with deep reserve capacity. The volt meter allows you to adjust the charge rate to compensate for battery type, size and quantity of batteries on a charge. The output leads are terminated in ring terminals and designed to be permanently attached to the Associated 6086 Parallel Battery Charging Rack, the Associated 6075 Parallel Bus Bar Kit, the Associated 6075CB Parallel Bus Bar Kit or the Associated 6075S Smart Parallel Bus Bar Kit.

The Associated 6012AGM battery charger has a high cranking assist of 250 amps to better start vehicles and offers a UL continuous rating of 70/60 amps for peak performance.The main feature is UL and cUL tested safe for indoor and outdoor use, "SAFE IN ANY WEATHER". Other features include a timer and 400-amp fully insulated clamps on twin extruded DC leads, for tangle-free operation. Made in USA".

611424 Associated Circuit Board For 6075S Parallel Bus Bar. The 6075S Wall Mount Parallel Bus bar set for parallel charging has just been revamped, Now with Smart Circuit Protection. Protects and monitors each circuit as it is being charged.

6058 Associated 8/12/16 Volt 20 Amp Portable Intellamatic Smart Automotive Battery Charger features a full 20 Amp charge rate for fast charging of most battery types. 8/12/16 Volt Intellamatic® SmartCharger is a fully automated microprocessor controlled charger capable of charging high efficiency, flooded, deep cycle, AGM and GEL batteries. Designed for everyday continuous operation. LED’s indicate the charging status of the battery and rocker switches select battery size and voltage. 8V for monoblock batteries – used on many golf carts. 12 V standard battery use. 16 V for high performance batteries. Unit will proceed to float charge, after battery is fully charged, keeping the battery ready and fully charged. MADE IN USA

ATEC® Hand-Held Battery Load Tester, Alternator and Starter Tester 135 Amp Fix Load Cables. Recessed meter helps protect this handheld tester from damage and ensures more accurate and reliable outputs. Features easy to use clamps with 300 Amp jaws. Lightweight and easy to use. Perform these diagnostic tests, State of charge, Battery load test, Starter test, Charging System test.

6141-25 Associated 6141 Associated AN2551 Aircraft Plug-In Cable 25Ft 4 Awg A/N Plug - This Aircraft Jumper Cable features a standard 3-pin Lexan female plug (equivalent to AN2551) on one end and alligator clamps on the other end.

High Speed Thermal Printer Serial With Cable

The ATEC 3100A Automatic Automotive battery charger provides fully automatic charging of 6 & 12 volt Standard, GEL and AGM battery types. Five charging modes are available 6V/2 Amp, 6V/8 Amp, 12V/2 Amp, 12V/15 Amp & 12V/100 Amp for engine starting. The built-in digital display shows the voltage before during and after charging, amperage and time on charge. Heavy-duty transformer and rectifier provide long life. Safety features include, built-in circuit protection, reverse polarity protection. Automatically checks for correct connection (requires a minimum of 1 volt DC at the battery terminals). Heavy-duty cables and clamps are corrosion-resistant for better connections. Clamps connect to side or top mount battery terminals. Ideal for charging or boosting during winter season when the starting performance of vehicle batteries is lowered by cold or extreme weather conditions.

Professional quality heavy duty 500 amp replacement clamps for all booster cables. Replace Associated clamps or other manufacturer's products with these professional quality insulated clamps. Clamps incorporate Associated's innovative "Flexi-Spring" for long cable life at the point it bends most. Possibly the best clamp in the industry.

Designed with highest quality and versatility in mind. Interprets data from the charging/starting system on easy-to-read LED display voltmeter and ammeter. Also shows +/- amps for easy diagnosis of current leakage problems. The 500 amp, carbon pile variable load capability, provides accurate load testing for up to 1,000 CCA batteries. A great time-saver for testing electrical systems on 12, 12/24 and 24 volt vehicles. Features include Large, easy to read, LED digital AMPS and VOLTS meters. Displays voltages to ±99.9 volts DC on the EXT position and up to 35.0 volts DC on the INT position. The AMP meter displays DC currents up to 999 amps and reads both + and - amps for easy diagnosis of leakage current problems. The carbon pile is rated 500 amps on 12 volt batteries for load testing batteries up to 1000 CCA capacity. Curved carbon discs allow better low end resolution of current and longer life. Defective Diode indicator light lets you know when alternator output diodes or GM diode trios have failed.

Professional quaIity, heavy-duty booster cables ensure quick and efficient connections. Associated Equipment has deslgned these cables wlth your safety and convenience in mind. From side terminal adapters and "Flexi-Spring" cable guards to insulated safety clamps and 100% copper jaws.