ZMAGW Zebra Instruments Z•Keeper Magnetic Wristband for Small Metal Parts - Z•Keeper's strong magnetic plate secures small parts like screws, nuts, bolts, and bits that are easily lost in grass, carpet, or attic insulation while performing service. Durable hook-and-loop fastener adjusts to any wrist comfortably. Locate Z•Keeper easily by touching it to the inside of a metal toolbox or any metal surface of a work truck or van.
ZCTRK Zebra Instruments Compressor Terminal Repair Kit - Terminals are high-temp soldered to the 10 ga. fine-strand, color-coded wires for the best connection. These special terminals allow clearance for compressor posts, and lay flat under the safety cover. Twist-on wire-nuts also provided.
ZK003 Zebra Instruments ZBreaker 24 Volt or 120 Volt 3 Amp Circuit Breaker (includes wires, plug-in terminals & mount) - The same circuit breakers now found on many high-end transformers and systems, but at a great price! Kit includes wires and pre-installed terminals that allow you to easily plug it in to the connectors where a plastic-type fuse existed. 3 Amp Size.
UZEXT Zebra Instruments Main Harness Extension or Replacement 24" for use with UZ-1 System - This product can be used in two different ways: As a 24" Extension of the UZ-1's main harness, making it a little easier to access those hard-to-reach motors, or As a replacement for the UZ-1's main harness, in case the original one was damaged or cut by a blower wheel, etc.
ZD002 Zebra Instruments Zebra'Dapter 24" Lighted Female Cordset with Glow-Plug and Safety Fuse - A Zebra'Dapter is a Fused Power Tap Cord (Cheater Cord.) It's standard 120V Plug is lighted to show the voltage level available: No Light means No Power. Normal Light means 120VAC Power is present. The Zebra'Dapter is a significantly SAFER way to obtain 120V Power to test 120V Motors and other devices. It has an In-Line Fuse to help make your jobsite safer! Two fuses included.
ZAPPRO Zebra Instruments Plug-In Surge & Spike Protector (120 - 240 Volt) - Plug-In Transient, Surge, Lightning, & Spike Protection for 120-240 Volt Condensing Units and Furnaces. To use, simply plug ZAP-PRO directly into contactor or circuit board, then attach ground strap... (Full instructions with photos in package). "The most common cause of Circuit Board component failure is damage as a result of poorly conditioned voltage." This unit works with either 120 volts or 240 volts.
ZG003 Zebra Instruments Zebra-Gators 8 Piece Medium Size Alligator Lead Set - Package of 8 Medium Size (up to 15 Amp) Alligator Jumper Wires. 24" Length, 8 different colors. Leads are soldered to clips so they don't fall off. Heavy carry pouch and velcro hang strap. Used on motor circuits; up to 15 Amps capacity.
UZHMB Zebra Instruments Universal Zebra Adapter "B" - Series 3.0 ECM Motors - The Adapter simply plugs in to the end of the Universal Zebra's harness, and then to the motor. A Magnetic Overlay Card is included that explains what functions the UZ-1's switches and LEDs perform for this specific series of ECM motor.
ZD001 Zebra Instruments Zebra'Dapter 72" Lighted Male Cordset with Glow-Plug and Safety Fuse - A Zebra'Dapter is a Fused Power Tap Cord (Cheater Cord.) It's standard 120V Plug is lighted to show the voltage level available: No Light means No Power. Normal Light means 120VAC Power is present. The Zebra'Dapter is a significantly SAFER way to obtain 120V Power to test 120V Motors and other devices. It has an In-Line Fuse to help make your jobsite safer! Two fuses included.
ZSPRT Zebra Instruments Short Finder (24 Volt Short Finder and More). Used to quickly locate shorts in 24VAC circuits while protecting controls from damage. The Short•Finder is a 24 volt system "short-finder". It'll keep the Tech from wasting a pocketful of fuses while trying to locate a control voltage short. A built-in circuit breaker turns on a bright red LED when tripped. As the Tech removes the short, the breaker can be flipped, the LED goes out, and the circuit is restored. Lightweight and compact, with two 18" leads.
VZH06 Zebra Instruments Condenser ECM Motor Adapters (with DVD) for VZ-7 - 3-Piece Adapter Set necessary to connect your VZ-7 to the new Condensing Unit ECM (Multi-Speed, Variable Torque) Motors by General Electric. Instructions on DVD Included.