Three pack of 1/4'' FE SAE tees with nuts by JB (A31444). Add multiple ports with just one fitting. The flare connections offer a safe, simple installation without the need to brazing. All of the flare ends are tapped to receive access cores. One core and cap are packaged with each valve.

Highest Quality on the Market
Made using the highest level of brass consisting of 65% copper and 35% zinc providing high tensile strength while resisting corrosion. Machined to exceed the strict guidelines of the ARI to ensure proper sealing of the valve and core surfaces. Fittings have generous counter bores to allow for the removal of the core if the flare becomes damaged. All valves are equipped with cap and one valve core (braze type, loosely assembled). Temperature range is -40º degrees to +250º degrees Fahrenheit. Valve core is stainless steel and brass for use with all refrigerants including R-410A. Resistant to oils, alkalites, and diluted mineral acids.

Made in the USA
Made by JBI in their Aurora, Illinois factory. Many import fittings use less quality brass with lower copper content and a higher failure rate.

Warning: This product may expose you to chemicals including lead which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov