Three pack of 1/4'' ODS forged brass braze run access tees by JB (A31544). One core and cap are packaged with each valve.

Highest Quality on the Market
Made using the highest level of brass consisting of 65% copper and 35% zinc providing high tensile strength while resisting corrosion. Machined to exceed the strict guidelines of the ARI to ensure proper sealing of the valve and core surfaces. Access fittings have generous counter bores to allow for the removal of the core if the flare becomes damaged. All tees and crosses are tapped to receive an access core in 1/4'' SAE flare ends. All pipe connections have internal braze cups for dip tube applications. All valves are equipped with cap and one valve core (braze type, loosely assembled). Temperature range is -40º degrees to +250º degrees Fahrenheit. Valve core is stainless steel and brass for use with all refrigerants including R-410A. Resistant to oils, alkalites, and diluted mineral acids.

Made in the USA
Forged by JBI in their Aurora, Illinois factory. Many import fittings use less quality brass with lower copper content and have a higher failure rate.

Warning: This product may expose you to chemicals including lead which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov