ESA30 OBD II Memory Saver Connector
Clore Automotive introduces the SOLAR ESA30 OBD II Memory Saver Connector, a memory saver connector that can be used in conjunction with a jump starter to preserve vehicle codes and electronic presets while a vehicle’s battery is disconnected. The ESA30 can be used on any jump starter with a 12 Volt power port. The ESA30 acts as an interface connector between a jump starter and a vehicle’s OBD II port. This prevents any electronic memory loss when disconnecting a vehicle’s battery. A proper connection is confirmed by the ESA30’s built-in LED light.
249-094-900 Red Positive Booster Clamp
Red Positive Booster Clamp features full power jaws (distributes full power to both jaws), heavy duty construction for durability and long life, solid copper jaws for better conductivity, and a braided internal power crossover strap instead of wire for even power to the jaws.
249-093-900 Black Negative Booster Clamp
Black Negative Booster Clamp features full power jaws (distributes full power to both jaws), heavy duty construction for durability and long life, solid copper jaws for better conductivity, and a braided internal power crossover strap instead of wire for even power to the jaws.
ESA5 Male To Male 15 Ft 12 Volt Outlet Charger Cord Jumper
ESA5 12 Volt extension cord Male cigarette lighter x Male cigarette lighter 15' adapter. Accessory used with many of our portable power sources including Booster PAC, Jump-N-Carry and Truck PAC. The cord can be used for charging the jump-pac after use, or for a quick charge of a vehicle from inside the drivers compartment out of the elements. We also have one in a 6ft. length here.
ESA1 Male To Male 12 Volt Outlet Charger Cord
ESA1 12 Volt extension cord Male cigarette lighter x Male cigarette lighter 48" adapter. Accessory used with many of our portable power sources including Booster PAC, Jump-N-Carry and Truck PAC. The cord can be used for charging the jump pac after use, or for a quick charge of a vehicle from inside the drivers compartment out of the elements.
ESA22 Charger W/ Small Jack
Wall Charger with pin type jack. For most units produced after 1999 with auto charging boards.
Discontinued See ESA214
249-066-666 Solar Booster Clamps Positive & Negative
Clamps Positive & Negative. Screw Type Connection for ring terminal cables to anchor wire for solderless connection. Dual Hot Jaws for better power distribution. Includes Phillips anchor screws. Does not include hardware for cables, (ring terminals, solder etc...).
Discontinued - replaced by 238-006-666
