Use GoodAll 14-500 replacement clamps when replacing clamps on starting units and heavy booster cables.  They feature solid copper jaws and heavy springs for high current surges.  Rated at 500 amps, these clamps are appropriate for heavy duty boosting up to semi tractors.  Skin packed 1 pair per package for convenience.

249-028-666 Christie Heavy Duty Mechanic Charging Clamps. Solid copper heavy jaws, 60% thicker than OEM jaws for greater output. Vinyl Coated for maximum insulation and spark protection. Easy crimp on jaw for high current. Designed for 6 to 1 gauge wire. Rated for 800 Amps. For individual clamps see 249-001-666 Positive Clamp  & 249-002-666 Negative Clamp.

Stop using outdated technology! Get the benefit of reverse current protection to keep your generator safe and advanced voltage regulation for today's sensitive vehicle electronics. Our Upgrade Kits provide simple operation with all the controls and instructions in one location.  You'll prefer the simplicity of full-power boosting through one set of cables. Upgrade Kits include Voltage Control provides regulated voltage that is safe for vehicles and on-board electronics. Reverse Current Shutdown Protection eliminates expensive repairs to the Start•All® if the unit runs out of gas. Reverse Polarity Protection will not allow the Start•All® to be turned on if the cables are not hooked up correctly. 30 ft., 1/0 cable with 1000 amp clamps with full-power jaws and polarity indicator. All-internal wiring, solenoids and switches, Volt and amp meters, Instructions and wiring diagram.

Stop using outdated technology! Get the benefit of reverse current protection to keep your generator safe and advanced voltage regulation for today's sensitive vehicle electronics. Our Upgrade Kits provide simple operation with all the controls and instructions in one location.  You'll prefer the simplicity of full-power boosting through one set of cables. Upgrade Kits include Voltage Control provides regulated voltage that is safe for vehicles and on-board electronics. Reverse Current Shutdown Protection eliminates expensive repairs to the Start•All® if the unit runs out of gas. Reverse Polarity Protection will not allow the Start•All® to be turned on if the cables are not hooked up correctly. (Your Unit must have 1/0 cables with 1000 amp clamps with full-power jaws to safely install a "No Cable" kit on your unit, older units had 2 gauge wire).

680-479 Goodall Pulley Bushing 1" Shaft

690-129 Goodall Cover Latch. Note: Includes latch only; Goodall 70-513 Strike sold separately. Requires drilling for mounting hole location.

Generator Pulley for use on all Start-All generators

70-333 Goodall Brush Arm & Spring (Old Style Generators)

70-374 Goodall Commutator End Plate (Old Style With Bronze Bearing Oiler). This is not to be fitted with newer style ball bearing generators.

70-385 Goodall Armature Dual Ball Bearing

70-390 Goodall Terminal Stud Brush Holder Package (Old Style Grounded Generators) See parts 70-333 brush arm & spring and 70-046 brush.

70-408 Goodall V-Belt Long 4L340R (712 716 718 920, B1600, B1800)

70-412 GoodAll Pulley, w/o Bush, 4/Groove

70-480S switch is a heavy duty, high voltage AC rated switch. It features a slow-make, slow-break contact mechanism, and fit the industry standard .500 diameter mounting hole. on, off, energize for models 716 718.

70-628 Goodall V-Belt Short 4L230R (712 716 718 920 Series B1600 B1800)

77-321S GoodAll Resistor Assembly

79-373 Goodall Field Coil For Older Generators. (Same as 79-398)

79-375S Goodall Generator Dual Ball Bearing Case Ground

79-375S-CR GoodAll Factory Rebuilt Generator B/B Ground Thru Case

79-392 GoodAll Brush Plate Assembly (79-371 Gen.)

Commutator End Plate for Bearing

79-396 GoodAll Brush Lead & Terminal, Carbon (79-371 Gen.)

79-398 Goodall Field Coil For 79-371 Generator

79-399 Goodall Ball Bearing For Generators (79-373, 79-375, 79-406)

79-400S Goodall Spring Set (for 79-371, 373, 375, 406)

79-405 GoodAll Brush Set, Carbon (79-375 generator)

79-411 GoodAll Insulator kit

79-500S Goodall Generator, Case Ground, 500 series

830-447S Goodall Ammeter 300-0-300 11-705 11-708 11-716 11-718 (70-447S)

830-520 Goodall Ammeter 300 Amp 11-610 11-620 (71-520S) with color indication for 11-610 11-620 11-900 series units. Replaces 70-447S & 830-447S.

860-224 Goodall Solenoid (77-181S1). Heavy duty solenoid rated for continuous duty. Do not replace with off brand or non specific units rated for starter duty. Also ideal for remote control of power circuits on battery charging systems, low-voltage DC motor generator sets, golf carts, and in-plant lift trucks.

880-205 Goodall Solenoid Copper Strap

880-408 GoodAll Brush (Each)

890-321 Goodall Resistor Assembly

890-437 Goodall Cable Clamp Assembly 30 Foot Duplex 2 Gauge (70-437S)