|
|
|
|
|
|
|
Product Features
- Century 80 GL welds 18 ga. sheet metal up to 1/8” steel
- Great for general purpose metal repair and building projects
- Two separate heat settings and an infinite wire speed control
- Uses 0.035 flux core welding wire on a 4” spool. No shielding gas needed (ED027641)
- Plugs into a standard 120 volt AC household outlet. No special wiring or receptacle needed
- Safe cold wire design. Arc is not established until trigger is pulled
- Sturdy wire feed design and multi-insulated transformer for reliable operation and long life
Recomended Processes:
-
The machine can be used for welding carbon and low-alloy steel through the self-shielded, Innershield® electrode process.
-
Innershield® NR-211-MP is a versatile wire suitable for all-position welding of light gauge or thin plate. It is recommended for maximum plate thicknesses in the range of 7.9 mm (5/16 in.) to 12.7 mm (1/2 in.). For an easy to use general fabrication wire – choose Innershield® NR-211-MP.
Operational Controls: The machine has the following controls as standard:
-
Power ON/OFF Switch
-
Heat Range Switch
-
Wire Speed Control
Design Features:
-
Operates on 115 volt input
-
Solid state output control
-
Overload protection - incorporates a thermostat to protect the welder from overheating caused by malfunctions or overly heavy use
-
Permanent magnet wire drive motor
-
Easy-to-set controls for arc voltage and wire speed
-
Thumbscrew release idle roll pressure arm is easily adjusted
-
Reversible, dual groove drive roll
-
Accommodates spools of wire up to 1 lbs(0.5 kg) in weight
-
No external shielding gas is required
Welding Capability:
-
The machine is rated at 70 amps, 17 volts, at 20% duty cycle on a ten minute basis
-
It is capable of higher output currents at lower duty cycles
Limitations:
The machine is recommended for welding on mild steel up to 1/8” thick
Includes:
-
80GL with work clamp, Gun and cable assembly attached
-
Nozzle
-
One contact tip for .035(0.9mm) diameter
-
Starter spool of .035 (0.9mm) NR211-MP flux core wire
-
Operator’s manual
Warranty:
|
|
|
|
|
|
|