41185 Titan 90amp Gasless Wire Feed Welder

   The 41185 Titan 90amp Gasless Wire Feed Welder is an easy-to-use gasless flux-core wire welder for the beginner, perfect for light duty repairs, maintenance and fabrication on light gauge steel around home, workshop and garage. Welds up to 1/8" thick mild steel but is not suitable for aluminum. Operates on 120V single-phase power with an Amperage range of 60 - 90 amps. Uses 0.030" to 0.035" diameter flux-core wire. Thermal overload protector automatically shuts off welder when duty cycle is exceeded. Fan cooled for better performance. One year limited warranty. Includes: Welding shield, welding hammer/brush, sample spool of flux-core wire, cold contractor MIG torch for added safety, earth clamp and welding cable.

   The VAPER flux wire welder is designed for use on standard 120V household current. It is equipped with a two step output power (amperage) control to select the proper current for various welding conditions. Internal components are thermostatically protected. This VAPER welder can weld steel ranging from 14 gauge up to 1/8” thick in a single pass. The unit is setup for 0.030” (0.8 mm) fl ux core welding wire when it leaves the factory.
ELECTRICAL REQUIREMENTS
This equipment requires a dedicated 120 volt 20 amp circuit equipped with a similarly rated circuit breaker or slow blow fuse. DO NOT run other appliances, lights, tools or equipment while operating this welder. EXTENSION CORDS ARE NOT RECOMMENDED for use with this welder.

• Easy-to-use gasless flux-core wire welder for the beginner
• Perfect for light duty repairs, maintenance and fabrication on light gauge steel around home, workshop and garage
• Welds up to 1/8" thick mild steel - not suitable for aluminum
• Operates on 120V single-phase power
• Amperage range: 60 - 90 amps
• Uses 0.030" to 0.035" diameter flux-core wire
• Thermal overload protector automatically shuts off welder when duty cycle is exceeded
• Fan cooled for better performance
• One year limited warranty

Includes: Welding shield, welding hammer/brush, sample spool of flux-core wire, cold contractor MIG torch for added safety, earth clamp and welding cable

Specifications
Type: 90 Amp gasless flux-core wire welder
Input Voltage: 120 Volt (1~60Hz)
Rated Output: 90 Amps @ 10% Duty Cycle
Output Power Settings: Switchable high/low adjustment
Output Current: 63.6 Amps - Low power output setting / 20% Duty cycle
90 Amps - High power output setting / 10% Duty cycle
Maximum Output Voltage: 32VAC
Power Switch: Illuminated On/Off Switch
Power Cord: 6 Ft 15 Amp Power Plug
Ground Cable & Clamp: 4.9 Ft Ground Cable with Clamp
Ground Cable Connection: Fixed Connection
Welding Cable: 6 Ft Wire feed welding cable
Welding Wire: Uses flux-core welding wire 0.030” (0.8mm) or 0.035” (0.9mm) in diameter

Warning: This product may expose you to chemicals including lead which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov