SS-120A-PE Schumacher Battery Charger Parts List
SchumacherSS-120A-PE Repair Parts
|
Part No.
| Description
| Qty
|
0090026088
| 115 Volt Power Cord
| 1
|
0499000035
| Mini Rocker Selector Switch SPDT(On-Off-On)
| 1
|
2299000884
| Heatsink SCR Assembly
| 1
|
2299001206
| PC Charging Board
| 1
|
3899000072
| Output Cables and Clamps (Red& Black) | 1
|
3899000737
| Output Cables and Clamps (Red& Black)
| 1
|
3999000072
| Circuit Breaker 35 Amp 1/4" Spade
| 1
|
5399100122
| Mode - State Meter Horizontal
| 1
|
| Schumacher SS-120A-PETroubleshooting Guide |
| PROBLEM | POSSIBLE CAUSE | SOLUTION |
| Red LED doesn't light (Automatic Mode). | Charger is not plugged in. | Plug in. |
| Connections are reversed. | With charger unplugged, reverse clamps and reconnect. (Rock back and forth to bite in.) |
| Poor electrical connection. | Clean clamps and battery posts and reconnect. (Rock back and forth to bite in.) |
| AC outlet is dead. | Plug in a lamp or other appliance to check for voltage. |
| Charger will not turn ON when properly connected to power. | Battery voltage is less than one volt. | Switch to MANUAL position for a few minutes. |
| Battery recently used in vehicle and is fully charged | Battery doesn't need charging. |
| Charger will not turn OFF. | Battery has problem and will not take full charge. | Have battery checked. |
| Two (or more) batteries connected in parallel. | Do not charge two batteries at the same time. |
| Battery of 200 ampere hours or larger. | Requires more time to charge: continue charging. |
| Battery is connected to application that draws a small current (such as a vehicle's dome light). | Requires more time to charge: continue charging. |
| Charger is in manual position. | You MUST unplug battery charger manually. |
Schumacher User Manuals Link
|
When a charging problem arises, make certain that the battery is capable of accepting a normal charge. Double check all connections, AC outlet for a full 120-volts, charger clips for correct polarity and the quality of the connections from the cables to the clips and from the clips to the battery system. The clips must be clean.
When a battery is very cold, partially charged or sulfated, it will not draw the full rated amperes from the charger. It is both dangerous and damaging to a battery to force higher amperage into it than it can effectively use in recharging.
*Variations of models due to production changes and parts availability are not our responsibility*No refunds on electrical components*Service should be performed only by a qualified technician*Please read all supporting documentation and safety instructions
