Identifier Switch ACR2000 This normally closed switch will cause the inlet test solenoid to close if the pressure of the sampled refrigerant is above 40 +/- 3 psi (276 +/- 21 kPa). The switch controls the flow of refrigerant to the identifier. It will reset at 27 +/- 3 psi (276 +/- 21kPa).
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Warning: This product may expose you to chemicals including lead which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov