312-067-666 Molded  Foot 6" Wheeled Units

Fan Blade 6" 4 Blade CW. Same as 130007-001 Christie

412-751-666 Chrome Battery Charger Handle. Replaces 442-020-166 and other older Century / Solar Handles

442-020-166 Century Battery Charger Handle. Flat side black painted finish.

512-127-000 Rectifier Insulator Standoff. Connects to the back wall of the charger chassis to provide a mount for the rectifier.

865-926-666 Century Rectifier 250 Amp 12 Diode 60 Amp Continuous Duty. Fits Most Older Century & Solar Models

The Century K3149-1 Automotive battery charger has features found on most commercial chargers at a price that can't be beat. A 200 amp 12v engine start helps start stubborn Engines and a 40 amp high, 20 amp medium and 2 amp low 12v charge settings for maximum range for most automotive batteries. 130 amp start and 40 amp high 6v charge setting for farm and fleet duty. A Low 2 amp setting is ideal for charging 12 volt motorcycle and lawn mower batteries. The Test feature identifies 12V battery and alternator problems, as well as indicates battery state of charge. Charges 6 & 12 volt maintenance free, conventional wet, deep cycle, AGM, and gel batteries used in cars, trucks, farm equipment, RV, boats and commercial applications.

S29420-1 Century Axle Cap Nut For 3/8" Axle (Each)

S29420-10 Century Negative Clamp

S29420-11 Century Positive Clamp

SLA90 Circuit Breaker, Open construction, automatic reset, 90 Amp, no terminal Hardware

S29420-13 Century Ammeter Horizontal 0-60 AMP range with boost. Features easy snap-in installation. White/Red Charge Rate face. 0-60 Amp range, wire through induction pick-up.

S29420-14 Century Voltmeter / Testmeter (Less PC Board)

S29420-16 Century Knob (Timer / Skirted)

S29420-17 Century Knob (Rate Switch)

S29420-18 Century 120 Minute Timer With Finish Bell.

S29420-19 Century 6 Position Rate Selector Switch

S29420-2 Century Wheels, Hubs, Axle Set For 6" Wheeled Units

S29420-21 Century Momentary Test Switch

S29420-22 Century Thermal Breaker

S29420-23 Century Handle (Wheel Charger)

S29420-24 Century Battery Charger Clamp Holder With Screws. Now you can stow your clamps in a safe place that doesn't get in the way, drag the ground or short out. Fits any round or flat bar battery charger handle. If using as a universal fit drilling two holes will be necessary.

S29420-3 Century 3/8" Axle

S29420-4 Century Fan Motor With Fan Blade & Bracket. For fan blade see 316-009-000.

S29420-5 Century Circuit Board For Volt/Test Meter

S29420-6 Century Power Cord SJTOW

S29420-7 Century Strain Relief

S29420-8 Century Negative Cable & Clamp Assembly 6ga

S29420-9 Century Positive Cable & Clamp Assembly 6ga