6075S Associated 300 Amp Parallel Bus Bar Kit 10 Pair Smart Circuit Protected

The 6075S Wall Mount Parallel Bus bar set for parallel charging has just been revamped, Now with Smart Circuit Protection. Protects and monitors each circuit as it is being charged. Individually Fused Circuits for safety. Microprocessor controller monitors each circuit against over charging, detects bad batteries and high heat build-up in batteries. Status LED for each Circuit. for the ultimate in safety and convenience. Insulated fiberglass backboard with 10 pairs DC charging leads, 4 gauge, 48" long with 300-amp insulated safety clamps. Use one or combine additional bars for added capacity. Use with Model 6065, Model 6066A or Model 6068 multiple parallel battery chargers. Can be used with other manufactured Parallel chargers.

Battery Charging Indicators
Fast Flashing Red: Reverse Battery
Green/Red: Not enough voltage to turn Relay on
2 Red / 1 Green: Relay issue
Flashing Green: (1s on/ 1s off) charging
Flashing Green: (2s on/ 1s off) charging above 14.4V
Slow Flashing Red: Current above 20A
Slow Flashing Red: Hot battery
Solid Green: Float Mode
Solid Red: Battery in Recovery did not rise up

6075S Replacement Parts
611424 PCBA (1 each)
611425 Positive Cable Clamp Assembly (1 Clamp)
611426 Negative Dual Cable Clamp Assembly (2 Clamps)
610069 DC Breaker (1 each)
6202 Positive & Negative Clamps
610970 Clamp Jaw Kit (Each)

Warning: This product may expose you to chemicals including lead which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov