1050-PE Schumacher Battery Charger Parts List
Schumacher 1050-PE Repair Parts
|
Part No.
| Description
| Qty
|
0090026054
| 115 Volt Power Cord
| 1
|
0499000034
| 2 Position Mini Rocker Switch
| 1
|
0499000035
| Mini Rocker Selector Switch SPDT(On-Off-On)
| 1
|
2299000947
| Heatsink Rectifier Assembly
| 1
|
3899000515
| Positive / Negative Cable andClamp Set
| 1
|
3899001954
| Positive / Negative Cable andClamp Set (14 Gauge, 7 ft) | 1
|
3899001996
| Positive / Negative Cable andClamp Set (12 Gauge, 7 ft)
| 1
|
3999000072
| Circuit Breaker 35 Amp, 1/4"Spade
| 1
|
5399100072
| Ammeter Horizontal 0-50 Amp
| 1
|
RR50
| Rectifier Diode Replacement Kit
| 1
|
| Schumacher 1050-PE Troubleshooting Guide |
| The battery charger is designed to work automatically. However, if a problem does occur, check the following: |
| PROBLEM | POSSIBLE CAUSE | SOLUTION |
| No meter reading | Clips not making good contact | Rock clips back and forth for a better connection. |
| Charger will not turn on when properly connected. | AC outlet is dead. | Plug in a known working lamp to check for voltage. |
| Poor electrical connection | Check connections rock clips back and forth. |
| Noise from charger even when not connected to a battery. | Transformer Hum. | Normal condition no solution necessary Charger is okay. |
| Clicking noise from charger. | Circuit breaker cycling. | May be in the wrong position. |
| Battery is defective. | Have battery checked. |
| Severely discharged batter but otherwise a good battery. | Allow charging to continue until battery has a chance to recover sufficiently ot take a charge. If more than 20 minutes, stop charging and have battery checked. |
| Reverse Battery connections. | Shut off charger and correct lead connections. |
| Schumacher User Manual Link |
When a charging problem arises, make certain that the battery is capable of accepting a normal charge. Double check all connections, AC outlet for a full 120-volts, charger clips for correct polarity and the quality of the connections from the cables to the clips and from the clips to the battery system. The clips must be clean.
When a battery is very cold, partially charged or sulfated, it will not draw the full rated amperes from the charger. It is both dangerous and damaging to a battery to force higher amperage into it than it can effectively use in recharging.
*Variations of models due to production changes and parts availability are not our responsibility*No refunds on electrical components*Service should be performed only by a qualified technician*Please read all supporting documentation and safety instructions
