0099000066 Schumacher Battery Charger Axle 3/8 Dia.15-3/8" Long.

0099000120 Schumacher Wheel 7" Plastic For 3/8 Axle

1199004366 Schumacher "U" Bracket For 3/8" Axle

1199005112 Schumacher Foot, Metal, no hardware included. For 8" Wheeled units.

Axle End Cap Fits .375 (3/8") Diameter Axle, Sold as a Pair, Can be used on any 3/8" Axle to secure wheels.

3599000662 Schumacher Battery Charger Handle Round Black Steel. Replaces handle part number 3599000136.

5100000005 Screw M3 X 5.5 For Original Timer

6 Position Rotary Selector Switch

PT16160 John Deere Circuit Breaker 12 Volt 50 Amp

Quad Force Rectifier Installation Kit, 250 Amp Cycle Duty, 60 Amp Continuous Duty, 8 Diode Ceramic Insulated Spider Design. Replaces Older Daisy Wheel Design.

Mechanically controls charging in timed Mode with manual hold mode. Single Pole Single Throw (SPST) Switch rated 15 amperes. Termination is designed to accept 1/4" spade terminals.

Horizontal Voltmeter Less Circuit Board With 0-20 Volt Range Battery Percent Of Charge Scale and Alternator Test Scale

PT18716CB John Deere Voltmeter Horizontal With Board

PT18717 John Deere Ammeter Horizontal 0-60 Amp Range

PT18718 John Deere Rotary Selector Switch

Cable Clamp assembly for John Deere. 300 Amp Max Capacity. Can be used on other units as well.

Cable Clamp assembly for John Deere. 300 Amp Max Capacity. Can be used on other units as well.

Horizontal Voltmeter Less Circuit Board With 0-20 Volt Range Battery Percent Of Charge Scale and Alternator Test Scale

PT20036CB John Deere Voltmeter Horizontal With Circuit Board Mounted. Panel Mount 0-20 Volt Range. If your unit does not have a circuit board mounted on the back, this unit will not replace the standard "non-board" meter.

Mechanically controls charging in timed Mode with manual hold mode. Single Pole Single Throw (SPST) Switch rated 15 amperes. Termination is designed to accept 1/4" spade terminals.

6 Position Rotary Selector Switch. Older Units used this switch and can be identified by the difference in cabinet mounting, this switch uses a threaded collar with jam nut to mount to case.

PT21003 John Deere Circuit Breaker 32 Volt DC 100 Amp

Horizontal Panel Mount Volt Meter. 6-12 Volt Range, Battery Percent Of Charge Scale and Alternator Test Scale. Bad - Weak - Good. 4 Point Snap In Mount. 1/4" Spade Terminals. Circuit Board Installed.

PT21008 John Deere Battery Charger Transformer 10/30/200 Amp 6/12 Volt

Heat Sink Rectifier, Dual Post Style Diode type.

PT21013 John Deere Circuit Breaker 32 Volt DC 90 Amp. When ordering, it may be necessary to purchase a pair of the 5199000406 screws if replacing and older circuit breaker for retrofit.

Circuit Breaker 35 AMP 1/4" Spade Terminal Connection

This Knob is for selector switches only, there are separate knobs for selector switches and timers. Please check your part numbers carefully.

Mini snap-in paddle handle rocker switch with are single pole double throw momentary contact arangement and a 10 amp rating.

TY1499 John Deere Selector Knob