126 TPI Compact Autoranging DMM W/Boot Test Leads And Manual

TPI 126 Compact Autoranging DMM W/Boot Test Leads And Manual - The 126 is a hand-held autoranging DMM. The 126 measures ACV, DCV, ACA, DCA, Resistance, Diodes and Continuity.

Agency Approval: Meets CE and IEC 1010 requirements.

Record: Records Min/Max values.

Range: Allows you to either manual range or use auto range to select the appropriate range.

Auto Off: Preserves battery life. LCD shows oFF when in this mode. Automatically powers down after 30 minutes of inactivity.

• 4,000 count display
• 0.3% DCV basic accuracy
• 0 to 600 ACV; max resolution 1mV
• 0 to 40MΩ; max resolution 0.1Ω
• Audible continuity
• 0 to 400 mA amps AC/DC; max resolution 0.01mA
• Autoranging
• Min/Max
• Data Hold
• cULus 61010-1
• CAT II - 1000V, CAT III - 600V

• 126 Instrument
• Rubber Boot
• Test Lead Set
• Battery
• Instruction Manual

• Thermocouples in furnaces or gas applications
• Thermocouples in furnaces of gas applications. DC Controlled circuits
• Heat anticipator current in thermostats
• Line voltage
• Control circuit voltage
• Flame safeguard control current
• Heating element resistance (continuity)
• Compressor winding resistance
• Contactor and relay coil resistance
• Continuity of wiring
• Temperature w/ optional temperature adapter

• Category I: Usually electronic equipment or equipment where measures have been taken to limit transient over voltages.


• Category II: Single phase loads like appliance personal computers, television sets, and other household loads. Outlets located more than 30 feet froma CAT III source or more than 60 feet from a CAT IV source.


• Category III: Distribution level fixed installations like distribution panel devices, short branch and feeder circuits, three phase loads, and single phase commercial lighting.


• Category IV: Equipment and lines located on the power line side of a service panel or where a low voltage connection is made to utility power