These gaskets fit 1/4" flare and 1/2 ACME standard hose fittings. If you are doing maintenance on you unit it's a good idea to replace these as well as they become crushed over time resulting in poor flow or restriction due to swelling. These are standard for some other vendors hoses as well.

30lb. R-12 / Universal Gas Refillable Refrigerant Tank. Red Vapor Blue Liquid Ported Valve. 30 lb. capacity refrigerant tank for R-12, R-22, R-502 (universal) with 1/4" Flare fittings

Designed to protect recevery systems from debris and deposits that would normally harm your unit. Large filter capacity provides long life. All steel construction with enamel finish resists corrosion and rusting.

50lb. R-12 / Universal Gas Refillable Refrigerant Tank. Red Vapor Blue Liquid Ported Valve. 50 lb. capacity refrigerant tank for R-12, R-22, R-502 (universal) with 1/4" Flare fittings

50 Lb. Refillable Refrigerant Tank Float Switch. Red Vapor Blue Liquid Ported Valve. 50 lb. capacity refrigerant tank for R-12, R-22, R-502 (universal) with 1/4" Flare fittings

30 Lb. Refillable Refrigerant Tank Float Switch. Red Vapor Blue Liquid Ported Valve. 30 lb. capacity refrigerant tank for R-12, R-22, R-502 (universal) with 1/4" Flare fittings

Power Cord - 110 Volt 16 Gauge. For heay duty cord see 551628.

Float Switch Cable Makes the connection between the float in the tank and the system relay. When the tank reaches 80% capacity, the float interrupts the control voltage to the system relay causing the unit to shut down.

90º 1/8" female pipe thread ball valve kit replaces many older style valves with a universal panel mount valve and a complement of fittings to adapt to most retro fits on most equipment. The valve is an hermetically sealed "KANTLEAK" Style Valve for years of trouble free service and a collar lock ring for panel mounting if needed.

Optional Float Cable and Relay assembly for Portable Recovery Units: 25200B 25175A 25150A. Enables recovery units to operate with 80% float tanks. This item has been discontinued, see 19225 Cable & RA19133 relay as replacements.

Rebuild Kit For 110 Dc Oil-Less Compressor

19652 Robinair Oil-Less Compressor For 25150A 25175A 25200B 17800B (Special order item)

Low Side Gauge For 25175a / 25200b

Discontinued Rectifier Board For 25175a

Robinair 19720 High Pressure Cutout For 25175a / 25176a / 25177a / 25200b / 25201b / 25202b

19753 Robinair Manifold Block 25175A

Bottom Case For 25000 Series

Spool Valve 25XXX Series Units

Case Front Cooltech Line

Rectifier Board 25176a

Manifold Block Replacement

These gaskets fit 1/4" flare and 1/2 ACME standard fittings. If you are doing maintenance on you unit it's a good idea to replace these as well as they become smashed over time resulting in poor flow.

Main Power Switch Controls the power between the power cord and the main board.

60" Red Standard Fitting (1/4" FFL) Enviro-Guard Hose is rated at 740 psi working pressure, 3700 psi burst pressure. Designed for today's High Pressure Refrigerants. Features an In-line ball valve for positive shut off preventing blow back when removing or installing them.

Enviro-Guard Hoses are constructed of special barrier material which prevent virtually any permeation of refrigerant, yet remains flexible. Meet all specifications for low permeation construction. 740 psi working pressure, 3700 psi burst pressure.

CRXTOSP1 Tank Overfill Protection Cable Shorting Plug allows the user to override the tank float safety device on most recovery units using a 3 pin brad Harrison cable. Screws in place at the cable end allowing the unit to start. (Always use a scale for accuracy when using this device) 30 & 50 pound tanks should never be filled to a level beyond 80% of tank capacity.

1/4 Flare Seal Cap with anchor retention strap prevents loss when not in use.

Red Light High Pressure Light / Tank Full Light - Indicates when the discharge pressure reaches 350 psi or when the recovery tank is full.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Float Relay Interrupts power from the system relay. The Tank Full light comes on when the float opens the circuit.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Main Power Switch Controls the power between the power cord and the main board.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Red Light 230v Tank full and high pressure lights. Informs user if tank is full or has high pressure.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Compound Gauge Indicates the pressure of the system being recovered.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Breaker 7 Amp Protects the unit from drawing too much current. If tripped, unit is completely inoperative.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.