Automotive tools & equipment

HVAC & Industrial supplies

Sales - parts -service


  Home > Battery Testers & System Analyzers > Carbon Pile Load Testers (Resistive) >

PST-200 Schumacher 100 Amp Digital Battery Load Tester Charging System Analyzer

PST-200 Schumacher 100 Amp Digital Battery Load Tester Charging System Analyzer
 
Alternative Views:


Price $79.98


Product Code: SHUPST-200
Qty:

Description Prop65
 
The PST-200 100 Amp Digital Battery Load Tester is microprocessor controlled. It makes for an easy and accurate load test with no need to time yourself to get accurate results. Bright, LED Digital Display indicates both voltage and test results. A unique 3-Step Design provides LED polarity check function, battery load test and charging system test readout. Automatically Turns Off the Load after 10 seconds and locks the voltage. Super-Grip Battery Clamps are heavy-duty and color-coded. Baked Enamel, Steel Case to keep cool. Rubber Insulated Carrying Handle–for comfort and safety. Checks both Battery and Charging System.
Product Features
  • 100 Amp Digital Battery Load Tester
  • Microprocessor Control–makes for an easy and accurate load test with no need to time yourself
  • Bright, LED Digital Display–indicates both voltage and test results
  • Unique 3-Step Design–LED polarity check function, battery load test and charging system test readout
  • Automatically Turns Off the Load–after 10 seconds and locks the voltage
  • Super-Grip Battery Clamps–heavy-duty and color-coded
  • Baked Enamel, Steel Case–ventilated to keep cool
  • Rubber Insulated Carrying Handle–for comfort and safety
  • Checks both Battery and Charging System
12 Volt Battery Analysis

Press “START TEST” & wait for 10 seconds.
Once automatic test cycle is completed, your test results will be:

1.
GREEN LIGHT = OK):
Battery capacity is good. May or may not be fully charged.
Determine state of charge by checking specific gravity (use hydrometer). If gravity is less than full charge, check for possible charging system trouble or electrical drain. Recharge battery to fully charged level.

2. GREEN + YELLOW LIGHT = OK BUT WEAK):
Review the load test result with the comparison chart on the tester cover to see if this battery is “OK” or not. If it is “OK”, go up to 1ST “OK” state. If it is not, go down to 3rd “WEAK” state.

3. YELLOW LIGHT = WEAK):
Battery capacity is unsatisfactory. Battery may be either: (1) defective or (2) partially discharged. To determine which, check specific gravity. If gravity is over 1.225, battery is considered defective. If gravity is under 1.225, recharge battery and re-test. If cell-to-cell gravity varies more than 0.025 (25 points), cell trouble may exist. If charging does not bring gravity to fully charged level, the battery is either sulfated or has lost active material.

4. RED LIGHT = BAD):
Battery may be defective (e.g. a bad cell).

NOTE: If pre-test battery voltage is below 12.3V, tester will not allow and should not perform the load test. Please fully charge battery and retest.


Browse for more products in the same category as this item:

Battery Testers & System Analyzers > Carbon Pile Load Testers (Resistive)
Battery Testers & System Analyzers
Schumacher Electric Battery Chargers