238-006-666 Clamp Kit 8 Foot 6 Gauge Parrot Jaw

8' 6AWG Welding Wire Lead Set with heavy duty polished clamps featuring coated clamp handles. a 50 lb. Jaw Strength provides positive connections and color coded wires make for easy identification. These even have molded strain relief built on the cables. Ring terminal connections make installation a snap.

246-041-666 Universal Selector Knob

246-041-666 Universal Selector Knob with set screw for controls with 1/4" Stem. Replaces all knobs with 1/4" diameter shaft. Fits 1/2 shaft and 3/4 style shaft stems.

246-211-666 Circuit Breaker SLA135

Circuit Breaker, Open construction, automatic reset, no terminal Hardware

246-408-000 6 Position Rotary Selector Switch (No Knob)

246-408-000 6 Position Rotary Selector Switch (No Knob). This switch has been modified from the original metal stem design to a plastic stem and the pin locations have changed. Switch should be wired number to number not by tab location.

Discontinued

246-408-666 Rotary Selector Switch 6 Position With Knob

246-408-666 Rotary Selector Switch 6 Position With Knob. This switch has been modified from the original metal stem design to a plastic stem and the pin locations have changed. Switch should be wired number to number not by tab location. Includes instructions.

Discontinued

246-513-666 Timer Knob (Slotted)

246-513-666 Timer Knob (Slotted) Special knob with slotted shoulders for controls with shaft pins.

246-515-666 Mechanical Timer With Knob 120 Minute

Mechanical Timer controls charging in timed Mode. Single Pole Single Throw (SPST) Switch rated 15 amperes. 120 minute total time with finish bell, two spade terminal connections.

Discontinued see 0099000094

247-159-666 Ammeter Horizontal 0-60 Amp Range

Ammeter Horizontal 0-60 Amp Range features easy snap-in installation, no tools required. Black Charge Rate face. 0-60 Amp range with start. Wire through induction pick-up for greater accuracy.

247-161-666 Voltmeter Horizontal 0-40 Volt Range

Voltmeter Horizontal 0-40 Volt Range

248-379-666 Century Current Limiting Board

Power Cord with Current limiting circuit board and leads, Replaces older style boards with resistors

Discontinued

412-749-666 Battery Charger Front Foot

412-749-666 Battery Charger Front Foot

412-751-666 Chrome Battery Charger Handle

412-751-666 Chrome Battery Charger Handle. Replaces 442-020-166 and other older Century / Solar Handles

413-115-666 Wheels Axle Hub Set

413-115-666 Wheels Axle Hub Set. 3/8" OD axle x 13-1/4" long.

442-020-166 Century Battery Charger Handle

442-020-166 Century Battery Charger Handle. Flat side black painted finish.

51-236 Goodall 250 Amp Heatsink Rectifier

51-236 Goodall 250 Amp Heatsink Rectifier Kit 60 Amp Continuous Duty, 12 Diode Daisy Wheel Design. Extra Long center studs for thick transformer lead wires.

Discontinued - see 865-682-666

512-127-000 Rectifier Insulator Standoff

512-127-000 Rectifier Insulator Standoff. Connects to the back wall of the charger chassis to provide a mount for the rectifier.

865-038-666 Quad Force Rectifier Heatsink Kit 250 Amp

Quad Force Rectifier Installation Kit, 250 Amp Cycle Duty, 60 Amp Continuous Duty, 8 Diode Ceramic Insulated Spider Design. Replaces Older Daisy Wheel Design. Heavier heatsink provides better heat dissipation for faster recovery during engine start. Longer life.

865-682-666 Heatsink Rectifier

865-682-666 Heatsink Rectifier.  Product as pictured.  Does not include any mounting hardware (512-127-000).

G246-408-666 Dayton Switch Rotary 6 Position (Dayton Units)

G246-408-666 Switch Rotary 6 Position. For Dayton Chargers Only.

TJ1-120MHB Universal Battery Charger 2 Hour Mechanical Timer

TJ1-120MB Universal Mechanical 2 Hour Timer With Finish Bell. Mechanically controls charging in timed Mode, has "Hold" for manual un-timed charging. Single Pole Single Throw (SPST) Switch rated 15 amperes. Termination is designed to accept 1/4" Quick Disconnect terminals. Includes mounting screws. Replaces many older mechanical timers.

Discontinued see 0099000094